Tutorial: How to finish a Latch Hook

Well, I did it! My first official finish for 2014 – and it’s a project that I’ve had, on and off, for the last 5+ years (most likely more – I can’t remember when I first bought this kit).

I finished the Snowmen latch hook off on Saturday, but this one below I’d actually finished around about 18 months ago, and never fully completed the whole thing. Which.. was just finishing off the edges and sewing it up. In retrospect, very easy.

The latch hook kits all seem to have the same directions for finishing off a completed latch hook, and are all rather useless, hence me putting this off for so long. I tried to search YouTube, but for once it’s let me down in terms of tutorial videos. I did come across a couple of blog posts, but they were a bit tricky to follow. So, trial and error ensued, and thanks to a couple of requests, I’m detailing the process. It’s by no means perfect, but I think I did a pretty decent job for my first go!

20140119-225430.jpg

Decent scissors were a must, to cut through the fabric. I also used some larger needles (Chenille, Size 18, according to the packet, although it doesn’t really matter), and some DMC Perle 5 thread. Perle 8 would work just as well, I think, it’s just that Spotlight only had the colour I wanted in Perle 5.

20140119-225439.jpg

I started by cutting about two squares up (just under an inch?) from the edge of the completed rug area. The straight side was obviously the easiest part, and so I started with this side. You could probably go a little closer, but in the end, it didn’t make a huge difference.

20140119-225450.jpg

I knotted off at one end, and tucked the fabric over. Then, it was just a simple matter of going through each square, one by one. I’ve tried to get a good picture to show what I did – basically, go on the diagonal, and make it loop over. Don’t worry too much if you catch the wool – I did this quite a bit and you can’t see from the other side, as long as the needle & thread are pulled through securely.

20140119-225521.jpg

Sometimes the canvas can be quite thick, and doesn’t move with the stitching (see above). Just fold it down as you get to the area, and it’ll stay in place as you stitch nearer to it.

20140119-225542.jpg

The rounded sides were a little trickier for me, but I continued with the rough pattern of two squares around the edge.  Less is more – you can always trim it if a certain bit gets too fiddly to work with, like I did.

20140119-225556.jpg

I did the corners in different ways, although I didn’t get a picture of the second one. In this one, I cut it down and folded it over, to try and make it a bit neater, however it didn’t really make a huge difference – the next one, it was 2 squares on either side and folded up nicely. As long as both sides are equal, and you keep them flat when sewing, they’ll sit quite nicely.

20140119-225607.jpg

I admit, the rounded areas aren’t the prettiest – when it went down 1 square each row, it was neater than when it went down 2 or 3 squares. Either way, the canvas is fairly easy to manipulate, and you should be able to do some kind of stitch on each diagonal square to catch the fabric. Don’t be worried about doing extra stitches, sometimes they are needed.

20140119-225615.jpg

As you finish each length of thread, knot it off and start another one. The finished product should hopefully end up something like this, roughly even around the whole thing. There is latch hook/rug binding which can be purchased to sew on top and produce a more polished finish, but I didn’t bother on this one – after all, nobody’s going to be looking at the back, and this is a Christmas themed rug anyway.

20140119-225622.jpg

The finished product! As you can see, it tucks well under and you can’t see where the stitching has come through. Relatively quick and simple to do, for a nice finished edge all round.

Luckily, I’ve only got one more that is rounded, and the rest of my latch hooks are rectangular or square, so it’ll be a lot quicker to sew along. I do have a couple of the “huggable” latch hooks which turn into a toy which have been proving to be a bit of a challenge – if I manage to work out what on earth I’m doing with those ones, I’ll try and put up a tutorial for that one too.

Advertisements

6 thoughts on “Tutorial: How to finish a Latch Hook

  1. This will be indispensable to me if ever I complete my latch hook project, Thanks! I was also thinking about using a hessian fabric or similar over the back of the canvas. Would you ever consider trying this?

    • Not a problem! I struggled in the beginning to work out how to finish it, so I figured I’d try and simplify it for others in the same boat as me.
      I hadn’t actually thought about putting anything behind it – depending on the purpose of the finished project, though, that would definitely be worth thinking about. I can’t imagine it’d be too hard to sew onto the back at all.

  2. I am finishing a rug that was half way done when I bought it at an estate sale. the binding is still intact on all 4 edges, and she did beautifully with it on, but I am having trouble with bunching and having the edger pucker as I finish a row. I take out some yarns thinking I have pulled it too tight. I am thinking now after seeing your example that I should just cut that binding off of the edges, that way it will move freely and not bunch the edges. I hope I have explained my problem clearly. I would love to hear back from you. peggy pena

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s